双组份打胶机的使用注意事项!

发布时间:2019/08/26    发布人:

现在的玻璃工程越来越普遍░,对打胶的要求也是越来越严格!于是一种方便快捷░,质量可靠的打胶设备出现了--双组份打胶机!下面小编就给大家介绍一下这种打胶机的使用注意事项!
Now glass engineering is becoming more and more popular, and the requirement of gluing is becoming stricter and stricter. So a convenient, fast and reliable gluing equipment appeared - two-component gluing machine! The following edition will introduce to you the use of this type of glue beater notice points!
1.由于双组份密封胶的固化需要一定时间░,因此░,已涂了双组份密封胶的玻璃应水平轻轻搬动。
1. Since the curing of the two-component sealant takes a certain time, the glass coated with the two-component sealant should be moved horizontally and gently.
2.A组•●、B组份胶应保持清洁░,严防异物进入胶中。
2. Group A and B glue should be kept clean and foreign bodies should be strictly prevented from entering the glue.
3.在连续工作过程中░,胶枪每次停止工作时间一般不得超过20分钟░,否则░,应用A组份胶冲出全部混合胶░,直至单一的A组份胶从枪口排出为止。
3. In the continuous working process, the rubber gun should not stop working for more than 20 minutes at a time. Otherwise, the whole mixture should be produced by using component A glue until a single component A glue is discharged from the muzzle of the gun.
4.高压胶管不得强行挤压•●、弯曲░,防止影响系统正常工作。
4. High-pressure hose shall not be forced to extrude or bend to prevent the normal operation of the system.

双组份打胶机
5.混胶器应经常保持畅通░,以保证良好的出胶效果。如遇堵塞情况░,可用丙酮浸泡后清洗。建议每5组清洗一次。
5. Mixers should be kept unblocked regularly to ensure good gumming effect. In case of blockage, it can be soaked in acetone and cleaned. It is recommended to clean every 5 groups.
6.当胶枪长时间不用时(超过一周)░,应拆下枪体使用溶剂将胶枪和混胶器内的残留胶体清洗干净。
6. When the rubber gun is not used for a long time (more than a week), the gun body should be removed and the residual colloid in the rubber gun and mixer should be cleaned with solvent.
7.不同双组份胶生产厂家所生产的胶内含杂质数量不同░,根据实际情况清晰B组分的过滤网及单向止回阀░,建议每两组清洗一次。
7. The amount of impurities in the glue produced by different two-component glue manufacturers is different. According to the actual situation, the filter screen and check valve with clear B component are recommended to be cleaned once for each two groups.
8.任何因胶体固化所造成的胶枪•●、管路或整机的故障░,一律不在保修范围之内。
8. Any malfunction of rubber gun, pipeline or whole machine caused by gel solidification is not covered by warranty.
9.定期给各泵的加油口加油░,应保证油雾器内不断油。
9. Regular refueling at the refuelling port of each pump should ensure continuous oil in the oil mist.
好了░,今天的内容就暂且给大家介绍到这里了!以上的精彩内容由双组份打胶机的小编整理提供░,更多的精彩内容请继续关注我们░,我们会定期发布更多的精彩内容░,请记住我们的官网:
Okay, today's content will be introduced to you here for the time being! The above wonderful content is provided by the small edition of two-component glue machine. More wonderful content please continue to pay attention to us. We will release more wonderful content regularly. Please remember our official website: .

www.kecimusic.com
友情链接:梦想彩票站  彩票89  928彩票  众合彩票  七匹狼彩票  55彩票  3号彩票  手机购彩  679彩票  彩38彩票  华人彩票  多多彩票  361彩票  快8彩票  诺亚彩票  MY310爱投彩票  800万彩票  盛兴彩票  福中彩票  777彩票