双组份打胶机调试的注意事项!

发布时间:2019/06/26    发布人:

为了使双组份打胶机有一个良好的工作░,对不同的产品我们要对双组分打胶机进行些微的调整░,下面小编就给大家总结一下双组份打胶机调试的注意事项!
In order to make the two-component glue punch have a good working efficiency, we need to make some minor adjustments to the two-component glue punch for different products. The following edition summarizes the matters needing attention in the debugging of the two-component glue punch.
1•●、在当天机器操作完毕后要把胶管内的胶冲出░,防止硬化;如果长时间不实用要注意用煤油清洗胶管和胶枪。
1. After the machine is finished, the glue in the rubber tube should be washed out to prevent hardening. If it is not practical for a long time, we should pay attention to cleaning the rubber tube and gun with kerosene.
2•●、双组份打胶机使用的硅酮胶或聚硫胶要注意杂质不能过高░,低质量的胶容易堵塞胶管的过滤系统░,造成出胶不畅或不均匀。
2. Silicone glue or polysulfide glue used in two-component glue beater should pay attention to the impurities should not be too high, low-quality glue is easy to block the filter system of rubber hose, resulting in poor or uneven glue production.

双组份打胶机
3•●、在更换胶的品种时要特别注意把双组份打胶机内残留的胶冲净░,好清洗░,因为不同品种甚至品牌的胶容易反应堵塞机器。
3. When changing the type of glue, special attention should be paid to rinsing the residual glue in the two-component glue beater, and it is better to clean it, because the glue of different varieties or even brands can easily react to clogging the machine.
4•●、液压站系统的压力░,不能调的太高░,要根据室内环境温度等实际情况░,调至满足胶嘴正常出胶均匀打胶即可。打开液压站时一定要打开胶枪░,否则B组份管路压力将升得很高░,造成安全事故。
4. The pressure of hydraulic station system can not be adjusted too high. According to the actual situation of indoor environment temperature, it can be adjusted to meet the normal tapping of rubber nozzles. When opening the hydraulic station, the rubber gun must be opened, otherwise the pressure of component B pipeline will rise very high, resulting in safety accidents.

www.kecimusic.com
友情链接:购乐彩  鼎丰彩票  e博彩票  9亿彩票  乐彩客  汇盈彩票  利威彩票  80彩票  云鼎彩票  9亿彩票  178彩票网  王牌彩票  608彩票  龙头彩票  时时彩票  800万彩票  购乐彩票  多多中彩票  k8彩票