Two-component glue beater is a special equipment to complete two-way sealing of hollow glass, which may present various problems in the operation process. After-sales service personnel of Jinan Xingsheng Machinery have separated many years'experience of debugging and customer's practical consumption. This paper summarizes the following experiences in the application and maintenance of two-component glue beater, and arranges them into the following articles in the hope of assisting in entering hollow glass. Friends of glass processing industry.
Common faults of two-component glue beater and treatment methods:
1. Rubber tapping from press plate of glue beater
The lifting pressure is too high.
(2) The barrel is too big to be suitable. When purchasing, the customer first measures the size of the press plate of his gluing machine. Now there are three specifications of the press plate on the market, 560mm, 565mm and 571mm.
(3) Damage and deion of pressure disk sealing ring, aging and hardening, replacement of new rubber ring.
2. Uneven mixing, white silk, gum
The air compressor is short of air pressure, the air volume is unstable, and the pressure is adjusted.
(2) There are viscera in the proportioning pump of the glue beater, and the proportioning pump is cleaned.
(3) The one-way valve of mixer of glue beater leaks out and replaces the one-way valve.
(4) Local infarction in mixer and gun passage of glue beater, cleaning mixer and pipeline.
3. Curing speed is too fast or too slow
(1) Higher temperature in summer, faster curing speed of glue. According to the situation, we can adjust the scale to the direction of big numbers (10, 11, 12, 13, 14), lower temperature in winter, slower curing speed of glue. According to the situation, we can reduce the scale to (9, 8, 7, 6).
(2) The proportion of component A and B is not adjusted properly, and the proportion of component A and B should stop mixing at 10:1 (volume ratio). There is a bias between the proportion shown on the scale of each glue beater and the proportion of glue produced in practice. Some glue beaters are adjusted to 14:1, but only 10:1 is needed in practice. Therefore, it depends on operators to distinguish this point. A barrel of component A glue (white glue) is just matched with a barrel of component B glue (black glue). If B glue is used more, it dries faster, adjust the scale to the larger number (10, 11, 12, 13, 14), if B glue is used less (slow drying, not dark enough, gray), adjust the proportion to the smaller number (9, 8, 7, 6).
Today, the content shared by everyone of Jinan Changsheng two-component glue punch is here. For more inion about the two-component glue punch, please consult our online customer service staff on the official website: . We will reply to you as soon as possible. Thank you for your support.