玻璃打胶机凝固速度与环境温度的关联

发布时间:2018/03/12    发布人:

中空玻璃打胶机撤出空桶░,将新胶桶置于工作位置░,重复第3•●、4•●、项操作。
The hollow glass glue machine withdraws the empty bucket, puts the new glue barrel in the working position, repeats the third, fourth and the operation.
1•●、胶枪:因双组份胶是由两种胶混合而成的░,其凝固速度与环境温度和A•●、B胶的比例有关░,混合后的胶一般在20分钟之内就会反应固化。所以░,当设备在正常打胶后░,20分钟之内不使用就必须将混合后的胶冲洗出来░,以免堵塞混胶器和胶枪。
1, glue gun: because the two component glue is made of two kinds of glue, its solidification speed is related to the ambient temperature and the proportion of A and B glue. After mixing, the glue will react and solidify in 20 minutes. Therefore, when the equipment is not used in 20 minutes after normal glue, the mixed glue must be flushed out in order to avoid blocking the mixer and glue gun.
1)松开比例杠杆上的比例泵锁紧螺钉░,将比例泵内外调整至所需比例。只有当A胶和B胶的配比达到正常值时░,才可进行下面的操作。

双组份打胶机
1) unlock the proportion pump locking screw on the proportional lever, and adjust the ratio pump to the required proportion. Only when the ratio of A glue and B glue reaches the normal value, the following operation can be carried out.
2)置选择旋钮于A•●、B泵开░,将胶枪出口对准两片玻璃的中缝░,打开胶枪开关░,以适当速度平稳地移动胶枪使玻璃槽内的双组份胶填满充实为佳。打胶结束时关闭胶枪。
2) set the option knob on A and B pump, open the rubber gun outlet to the two piece of glass seam, open the glue gun switch, and move the glue gun smoothly at a suitable speed, so that the two component glue in the glass tank can be filled and enriched. Turn off the glue gun at the end of the glue.
3)打开 中空玻璃打胶机A(或B)胶泵充气开关░,选择A(或B)胶泵提升机构为上升位置░,点动旋钮使压盘慢慢提起░,此时应注意:胶桶尽量不要离开底盘░,直至压盘完全脱离胶桶时关闭A(或B)胶泵的充气开关。
3) open the hollow glass glue machine (A or B) inflatable rubber pump switch, select A (or B) rubber pump lifting mechanism for upward position, move the knob plate slowly lift, you should pay attention to: plastic barrel so as not to leave the chassis, turn off A until the platen completely out of plastic barrel when (or B) the inflatable rubber pump switch.
4)中空玻璃打胶机具体操作:将B泵关闭░,打开B胶回流开关然后打开胶枪░,至胶条为白色即可。
4) the concrete operation of the hollow glass rubber machine: the B pump is closed, the B glue reflux switch is opened and the glue gun is opened to the white glue bar.
5)把中空玻璃打胶机混合器放到水火烧░,直到把混合芯拿出为至;注黑把手里面还有一结。混合器和枪头之间的旋转部位不可烧;枪头不可烧?捎锰看蛲ㄎ
5) put the mixer of the hollow glass glue machine into the water and fire until the mixed core is taken out, and there is a knot in the black handle. The rotating parts between the mixer and the gun head are not burned, and the head of the gun can not be burned. The wire can be made through the wire
本文由双组份打胶机友情奉献.更多有关的知识请点击:我们将用先进的技术.真诚的态度.为您提供为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待
This article is a friendship contribution from two component glue machine. Please click on more related knowledge: , we will use the most advanced technology and the most sincere attitude to provide you with the most comprehensive service. We will dedicate more knowledge to you. Please look forward to it.
  

www.kecimusic.com
友情链接:福盈彩票  正点彩票  彩票宝  顺盈彩票  58彩票网  鼎宝彩票  鼎丰彩票  汇赢网  皇家88彩票  80彩票  皇家88彩票  58彩票  多多中彩票  乐享彩票  百万彩票  博九彩票  666彩票  必威彩票  68彩票网  头彩网